Modified Experiment
⚡⚡⚡Modified Experiment⚡⚡⚡
How does the ratio between yeast and flour affect the fluffiness and width of mantou?
(Height is deleted as it does not seem to be a good dependent variable. It does not have a correlation with the yeast-to-flour ratio according to the previous experiment)
(Height is deleted as it does not seem to be a good dependent variable. It does not have a correlation with the yeast-to-flour ratio according to the previous experiment)
Hypotheses
💨 1:60 is the optimal ratio to produce the fluffiest mantou (Same)
💨 No correlation between Y-F ratio and height (Base on results of first experiment, a correct assumption)
💨 Negative correlation between Y-F ratio and width (Higher ratio leads to shorter width)
Before Cooking
5W
What to prepare?
🧸 Ingredients: All-purpose flour, sugar, salt, milk, instant yeast, oil
🧸 Equipment: mixing bowls, aluminum foil, steamer, roller, wet towel, utensils , cling wrap, plate, ruler, memo, pen
Who conduct?
💥 Lam Ting Hin, Justin
Where to obtain materials?
💫 Ingredients purchased from market: All-purpose flour
💫 Ingredients purchased from supermarket: milk, instant yeast
💫 Ingredients obtained from home: sugar, salt, oil
💫 Obtain equipment and cook at: My Home Kitchen
When conduct?
🌡️ Apr 02 2020 11:20 am
🌡️ Temperature: 20.1 °C
🌡️ Humidity: 86%
Why conduct?
💦 Investigate in the effects of change in yeast-to-flour ratio on the fluffiness (gas bubbles, softness, skin smoothness) and width of a steamed mantou, in hopes of identifying an optimal yeast-to-flour ratio for the fluffiest mantou.
💦 Mantou is a kind of bread which allows me to observe the fluffiness easily since it only consists of the basic ingredients of a bread (less affected by other variables).
Variables
Independent Variable
|
Dependent Variables
|
Controlled Variables
|
Ratio between yeast (Y) and flour (F)
🍞 1:30 (10g Y:300g F)
🍞 1:40 (7.5g Y:300g F)
🍞 1:60 (5g Y:300g F)
🍞 1:80 (3.75gY:300gF)
|
Fluffiness and width of mantou
🍞 Fluffiness: gas bubbles, softness, skin smoothness
🍞 Width
|
Other variables other than ratio between yeast and flour, e.g.
🍞 Type of ingredients
🍞 Amount of other ingredients
🍞 Mixing, kneading, rising and steaming time
🍞 Cooking environment and temperature
🍞 Size of mantou before fermentation
|
During Cooking
Y-F ratio will be changed as follows:
🦄 1:30 (10g Y:300g F)
🦄 1:40 (7.5g Y:300g F)
🦄 1:60 (5g Y:300g F)
🦄 1:80 (3.75gY:300gF)
Experiment Details
🌟For tidiness, ALL photos and clips are condensed into a video. Watch the below video first before proceeding🌟
The experiment was repeated 4 times, each with different yeast-to-flour ratios.
Yield: 4 servings (~ 10-12 Mantou)
Preparation Time: 1 hours 58 minutes
Cook Time: 27 minutes
Total Time: 2 hours 25 minutes
Ingredients
All-purpose flour
|
300g
|
Sugar
|
40g (More sugar added as it was not sweet enough in previous experiment)
|
Salt
|
1g (Less salt added as it was salty in previous experiment)
|
Milk
|
180ml
|
Instant yeast
|
3.75g/5g/7.5g/10g
|
Oil
|
10ml
|
Steps
1️⃣ Preparation
2️⃣ Place the flour, instant yeast and sugar into a mixing bowl. Gently mix it.
3️⃣ Slowly add oil, salt and warm milk. Continue to knead and add milk as a dough ball is formed. If it is hard and dry, add more milk. If it is too wet and sticky, add more flour. At the end, the dough ball should be smooth, soft and non-sticky.
4️⃣ Put the dough into a flour-covered bowl, then cover it with plastic wrap or wet towel and set aside to rest. For experimental purpose, some 4cm*4cm*4cm cubes are cut from the dough to control the size of mantou before fermentation. Let the dough rest for around 60 minutes, whichever earlier.
5️⃣ Label the 4 doughs and the control mantou brought from a baking store to ensure correctness.
6️⃣ Place the dough on a flour-covered workstation. Roll it into a 4-5mm thick rectangular log. Flatten the log using a rolling pin. (Thickness is increased because the previous mantous were too small)
7️⃣ Starting from the long side of the dough, roll it towards the other end to form a log. Slightly brush some water at the end to tighten the log.
8️⃣ Slice the log into pieces of 4cm and place them on an aluminum foil. Lightly dab the surface of the buns and the separated piece with some milk to smooth the surface. Then loosely cover it with a damped towel and let it rest again for 30 minutes, whichever earlier.
9️⃣ Put the buns into the unheated steamer. Leave the lid with a little gap. Steam on medium heat for 20 minutes. After turning off the heat, keep the lid on for extra 7 minutes to prevent the buns from becoming saggy.
Source: http://sweetheartkitchen.com/recipes/mantou/
After Cooking
What to investigate?
🐾 Investigate in the effects of change in yeast-to-flour ratio on the fluffiness (gas bubbles, softness, skin smoothness) and width of a steamed mantou.
When to measure result?
🐣 Measure experiment results immediately after mantous are steamed
How to measure?
🐤 For each trial, 4 mantous are used for result measurement. Their widths are averaged into the final result for fairness.
🐤 The results of fluffiness are concluded after observing 4 mantous of the same type and comparing with the control.
🐤 For fluffiness, the result is concluded after observing all 4 mantous.
🐤 Use a ruler to measure the width of mantous immediately after steaming.
🐤 Slice the mantou into half to observe the gas bubbles and skin smoothness of the mantou, then slightly press from the top to observe the softness.
Analysis
Measurement Table
Y-F Ratio
|
Measurement
Time
|
Width
(cm)
|
1:30
|
13:24
|
6.4
|
13:25
|
7.3
|
|
13:26
|
6.9
|
|
13:27
|
6.7
|
|
Average
|
6.825
|
|
1:40
|
13:32
|
6.6
|
13:33
|
6.5
|
|
13:34
|
6.3
|
|
13:35
|
6.3
|
|
Average
|
6.425
|
|
1:60
|
13:38
|
5.8
|
13:40
|
6.0
|
|
13:41
|
5.8
|
|
13:42
|
6.2
|
|
Average
|
5.95
|
|
1:80
|
13:45
|
5.3
|
13:46
|
5.5
|
|
13:47
|
5.1
|
|
13:48
|
5.1
|
|
Average
|
5.25
|
🦆 Negative correlation between DV and IV, so the hypothesis is also accepted.
🦆 Reason behind: When the dough ferments, it tends to grow horizontally. So, the more yeast used, the wider the dough grows.
Y-F Ratio
|
Gas Bubbles
|
Softness
|
Skin Smoothness
|
1:30
|
Many gas bubbles scattered
|
Extremely easy to squeeze
|
Roughest
|
1:40
|
Quite many gas bubbles scattered
|
Easy to squeeze
|
Rough
|
1:60
|
Average gas bubbles scattered
|
Need to apply slight force to squeeze
|
Smooth
|
1:80
|
Only a few gas bubbles present
|
Need to apply larger force to squeeze
|
Smoothest
|
Reasons behind:
🍀 As the proportion of yeast increases when amount of flour is kept constant, more tiny air bubbles are formed and scattered around the whole mantou. This creates more air pockets, thus enhances the softness of the bun.
🍀 As for skin smoothness, the degree of fermentation intensifies when the ratio decreases, leading to more air bubbles and holes. As a result, the skin becomes rougher.
Possible Errors
🍂 Manual Error. Hand gestures manipulated the size of mantou before steaming, leading to inaccurate size measurement.
🍂 Improvement: Fill the dough into a mold for size control
🍂 Inconsistent ingredients amount and time. May have slight discrepancies in ingredients amount and time throughout the 4 trials.
🍂 Improvement: Use more precise tools for measurement, e.g. syringe, electronic scale,…
🍂 Space limited during steaming. The buns are quite packed on a plate during steaming, which may impact their sizes.
🍂 Improvement: Steam fewer buns at a time and plate them dispersedly.
🍂 Subjectivity. When measuring the fluffiness based on observation, subjective errors may occur as I am the only experimenter.
🍂 Improvement: Include more experimenters and allow others to feel the texture.
Control Variables really kept controlled?
🌍 Some of the variables remain controlled, e.g. type of ingredients, cooking time…
🌍 Yet, in a household environment with simple equipment, some variables are hard to be controlled, e.g. exact amount of ingredients, temperature, humidity, kneading force, etc.
Minimizing Errors
🌠 To finish the experiment within the shortest period of time to lessen environment variation.
🌠 Double check each procedure to reduce manual errors.
🌠 Use quality and professional equipment when possible.
🌠 Do experiment in a controlled environment if possible.
**Modification**
💮 Cancel measurement about height as it is not correlated with the yeast-to-flour ratio
💮 Slightly modify the amount of sugar and salt
💮 Slightly modify the size of the rectangular dough log
💮 Changed title to measure width only but not height
Comments
Post a Comment